Service Manual

NOTE: The flow control must be off (rx off tx off) before configuring the half duplex.
Example (partial)
Dell(conf-if-tengig-0/1)#show config
!
interface TenGigabitEthernet 0/1
no ip address
switchport
no negotiation auto
flowcontrol rx off tx on
no shutdown
...
Example (Monitor
Session)
Dell(conf-if-te-1/5)#show config
!
interface TenGigabitEthernet 1/5
no ip address
shutdown
flowcontrol monitor 5
Example (Values)
This Example shows how the Dell Networking OS negotiates the flow control values between two Dell Networking
chassis connected back-to-back using 1G copper ports.
Configured
LocRxConf LocTxConf RemoteRxConf RemoteTxConf
off off off off
off on
on off
on on
off on off off
off on
on off
on on
on off off off
off on
on off
on on
on on off off
off on
on off
on on
LocNegRx LocNegTx RemNegRx RemNegTx
off off off off
off off off off
off off off off
off off off off
off off off off
off off off off
off on on off
off off off off
off off off off
on off off on
on on on on
on on on on
off off off off
off off off off
on on on on
on on on on
510
Interfaces