Service Manual

Slot/Port information must contain a space before and after the dash. For example,
interface range tengigabitethernet 0/1 - 5 is valid; interface
range tengigabitethernet 0/1-5 is NOT valid.
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example (Single
Range)
This example shows how to define an interface range macro named test. Execute the show running-config
command to display the macro definition.
Dell(config)# define interface-range test tengigabitethernet0/0-3,
tengigabitethernet 5/0-7
Dell# show running-config | grep define
define interface-range test tengigabitethernet0/0-3, tengigabitethernet5/0-7,
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,te-5/0-7)#
Related Commands
interface range – configures a range of command (bulk configuration)
interface range macro name – runs an interface range macro.
interface range macro name
Run the interface-range macro to automatically configure the pre-defined range of interfaces.
Syntax
interface range macro name
Parameters
name Enter the name of an existing macro.
Defaults none
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
516 Interfaces