Service Manual

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example (Single
Range)
This example shows the macro named test that was defined earlier.
Dell(config)#interface range macro test
Dell(config-if-range-te-0/0-3,te-5/0-8)#
Related Commands
interface range — configures a range of command (bulk configuration).
interface range macro (define) — defines a macro for an interface range (bulk configuration).
interface vlan
Configure a VLAN. You can configure up to 4096 VLANs.
Syntax
interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id Enter a number as the VLAN Identifier. The range is from 1 to 4096.
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
For more information about VLANs and the commands to configure them, refer to the Virtual LAN (VLAN)
Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC/IP ACLs are not supported.
Example
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related Commands
interface — configures a physical interface.
interface port-channel — configures a port channel group.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax
intf-type cr4 autoneg
Interfaces 517