Service Manual
V - VLT tagged
Name: TenGigabitEthernet 3/2
802.1QTagged: Hybrid
Vlan membership:
Q Vlans
U 20
T 10
Native VlanId: 20.
Dell(conf)#
Example
(unconfigure the
hybrid port)
Dell(conf-if-vl-20)#interface vlan 10
Dell(conf-if-vl-10)#no untagged tengig 0/2
Dell(conf-if-vl-10)#interface vlan 20
Dell(conf-if-vl-20)#no tagged tengig 0/2
Dell(conf-if-vl-20)#interface tengig 0/2
Dell(conf-if-te-0/2)#no portmode hybrid
Dell(conf-if-vl-20)#
Related Commands
show interfaces switchport — displays the configuration of switchport (Layer 2) interfaces on the switch.
vlan-stack trunk— specifies an interface as a trunk port to the Stackable VLAN network.
rate-interval
Configure the traffic sampling interval on the selected interface.
Syntax
rate-interval seconds
Parameters
seconds Enter the number of seconds for which to collect traffic data. The range is from 5 to 299
seconds.
NOTE: For 0 to 5 seconds, polling occurs every 5 seconds. For 6 to 10
seconds, polling occurs every 10 seconds. For any other value, polling occurs
every 15 seconds.
Defaults 299 seconds
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The output of the show interfaces command displays the configured rate interval, along with the collected
traffic data.
Related Commands show interfaces — displays information on physical and virtual interfaces.
Interfaces 527