Service Manual

off Brings the interface down when an RFI error is detected.
Defaults ON.
Command Modes INTERFACE CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Introduced on the MXL switch.
Usage Information
By default, the switch processes the RFI errors transmitted by remote peers and brings down the interface when
an RFI error is detected.
Example
Dell(conf-if-te-1/3)#remote-fault-signaling rx ?
on Enable
off Disable
show config
Display the interface configuration.
Syntax
show config
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
no shutdown
Dell(conf-if)#
show config (from INTERFACE RANGE mode)
Display the bulk configured interfaces (interface range).
Syntax
show config
Command Modes CONFIGURATION INTERFACE (conf-if-range)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Interfaces 529