Service Manual

To enter ROUTER RIP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the router rip command. The prompt changes to include (conf-router_rip).
You can return to CONFIGURATION mode by using the exit command.
SPANNING TREE Mode
To enable and configure the Spanning Tree protocol, use SPANNING TREE mode. For more information, refer to Spanning Tree Protocol
(STP).
To enter SPANNING TREE mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the protocol spanning-tree stp-id command. The prompt changes to include (conf-stp).
You can return to CONFIGURATION mode by using the exit command.
CLI Basics 53