Service Manual

Example
Dell(conf)#interface range tengigabitethernet 1/1 - 2
Dell(conf-if-range-te-1/1-2)#show config
!
interface TenGigabitEthernet 1/1
no ip address
switchport
no shutdown
!
interface TenGigabitEthernet 1/2
no ip address
switchport
no shutdown
Dell(conf-if-range-te-1/1-2)#
show interfaces
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
interface Enter one of the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a management interface, enter the keyword ManagementEthernet then the
slot/port information. The slot range is 0 to 1 and the port range is 0.
•
For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
NOTE: This command also enables you to view information corresponding to
a range of ports. However, for Open Networking (ON) platforms the notation
for specifying port range in the command is different from how you specify in
non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-
range. For example, if you want to display information corresponding to all
ports between 1 and 4, specify the port range as
show interfaces
interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/
[subport] - slot/port/[subpot]. For example, if you want to
display information corresponding to all ports between 1 and 4, specify the
port range as show interfaces interface-type 1/1/1 - 1/4/1.
Command Modes
• EXEC
• EXEC Privilege
530 Interfaces