Service Manual

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show interfaces description command shown in the Example below.
Field Description
Interface Displays the type of interface and associated slot and port number.
OK? Indicates if the hardware is functioning properly.
Status States whether the interface is enabled (up) or disabled (administratively down).
Protocol States whether IP is enabled (up) or disabled (down) on the interface.
Description Displays the description (if any) manually configured for the interface.
Example
Dell#show interface description
Interface OK Status Protocol Description
TenGigabitEthernet 0/1 NO admin down down
TenGigabitEthernet 0/2 NO admin down down
TenGigabitEthernet 0/3 NO admin down down
TenGigabitEthernet 0/4 NO admin down down
TenGigabitEthernet 0/5 NO admin down down
TenGigabitEthernet 0/6 NO admin down down
TenGigabitEthernet 0/7 NO up down
TenGigabitEthernet 0/8 YES up up
Related Commands
show interfaces – displays information on a specific physical interface or virtual interface.
show interfaces stack-unit
Display information on all interfaces on a specific MXL switch stack member.
Syntax
show interfaces stack-unit stack-unit-number
Parameters
stack-unit-number Enter the stack unit number. The range is from 0 to 5.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show interfaces stack-unit 0
TenGigabitEthernet 0/1 is down, line protocol is down
Hardware is DellForce10Eth, address is 00:1e:c9:f1:00:05
Current address is 00:1e:c9:f1:00:05
Server Port AdminState is Down
Pluggable media not present
Interface index is 34148609
Internet address is not set
Mode of IP Address Assignment : NONE
DHCP Client-ID :tenG130001ec9f10005
Interfaces 537