Service Manual

Related Commands
interface — configures a physical interface on the switch.
show ip interface — displays Layer 3 information about the interfaces.
show interfaces — displays information on a specific physical interface or virtual interface.
show interfaces transceiver — displays the physical status and operational status of an installed transceiver. The
output also displays the transceiver’s serial number.
show interfaces transceiver
Display the physical status and operational status of an installed transceiver. The output also displays the transceiver’s serial number.
Syntax
show interfaces {tengigabitethernet slot/port | fortyGigE slot/port}transceiver
Parameters
tengigabitethernet For a 10G interface, enter the keyword tengigabitethernet then the slot/port
information.
NOTE: This command also enables you to view information corresponding to
a range of ports. However, for Open Networking (ON) platforms the notation
for specifying port range in the command is different from how you specify in
non-ON platforms.
For non-ON platforms, you can specify multiple ports as slot/port-
range. For example, if you want to display information corresponding to all
ports between 1 and 4, specify the port range as
show interfaces
interface-type 1/1 - 4.
For ON platforms, you can specify multiple ports as slot/port/
[subport] - slot/port/[subpot]. For example, if you want to
display information corresponding to all ports between 1 and 4, specify the
port range as show interfaces interface-type 1/1/1 - 1/4/1.
fortyGigE For a 40G interface, enter the keyword fortyGigE then the slot/port information.
Command Modes
EXEC
EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface configurations
corresponding to a range of ports.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show interfaces transceiver command shown in the following example.
Line Description
Rx Power
measurement type
Output depends on the vendor, typically either “Average” or “OMA” (Receiver optical
modulation amplitude).
Temp High Alarm
threshold
Factory-defined setting, typically in Centigrade. Value differs between SFPs and SFP+.
Interfaces 541