Service Manual

If you configure the wavelength on a non-tunable optic, there is no change to the existing wavelength. The
configured wavelength is saved in the running configuration and is applicable, when a tunable optic is used.
If you do not configure the wavelength on an inserted tunable optic, the existing wavelength is used.
Example
The following example shows the wavelength set for a tunable 10–Gigabit SFP+ optic:
Related Commands
• show config — displays the interface configuration.
Port Channel Commands
A link aggregation group (LAG) is a group of links that appear to a MAC client as if they were a single link according to IEEE 802.3ad. In the
Dell Networking OS, a LAG is referred to as a Port Channel.
• For the switch, the maximum port channel ID is 128 and the maximum members per port channel is 16.
Because each port can be assigned to only one Port Channel, and each Port Channel must have at least one port, some of those nominally
available Port Channels might have no function because they could have no members if there are not enough ports installed. In the switch
module, those ports could be provided by stack members.
NOTE: The Dell Networking OS implementation of LAG or Port Channel requires that you configure a LAG on both switches
manually. For information about Dell Networking OS link aggregation control protocol (LACP) for dynamic LAGs, refer to the
Link Aggregation Control Protocol (LACP) chapter. For more information about configuring and using Port Channels, refer to
the Dell Networking OS Configuration Guide .
channel-member
Add an interface to the Port Channel, while in INTERFACE PORTCHANNEL mode.
Syntax
channel-member interface
To delete an interface from a Port Channel, use the no channel-member interface command.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
Defaults Not configured.
Command Modes INTERFACE PORTCHANNEL
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Interfaces 549