Service Manual

Example
Dell(conf)#int port-channel 2
Dell(conf-if-po-2)#
Related Commands
channel-member — adds a physical interface to the LAG.
interface — configures a physical interface.
interface vlan — configures a VLAN.
shutdown — disables/enables the port channel.
minimum-links
Configure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the LAG to be also in “oper up”
status.
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up” status. The range is from 1
to 16. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
If you use this command to configure the minimum number of links in a LAG that must be in “oper up” status, the
LAG must have at least that number of “oper up” links before it can be declared as up. For example, if the required
minimum is four, and only three are up, the LAG is considered down.
port-channel failover-group
To configure a LAG failover group, access PORT-CHANNEL FAILOVER-GROUP mode.
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group command.
Defaults none
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
552 Interfaces