Service Manual

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This feature groups two LAGs to work in tandem as a supergroup. For example, if one LAG goes down, the other
LAG is taken down automatically, providing an alternate path to reroute traffic, avoiding oversubscription on the
other LAG. You can use both static and dynamic (LACP) LAGs to configure failover groups. For more information,
refer to the Port Channel chapter in the Dell Networking OS Configuration Guide.
Related Command
group — groups two LAGs in a supergroup (“fate-sharing group”).
show interfaces port-channel — displays information on configured Port Channel groups.
show config
Display the current configuration of the selected LAG.
Syntax
show config
Command Modes INTERFACE PORTCHANNEL
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
Dell(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
Syntax
show interfaces port-channel [channel-number] [brief]
Parameters
channel-number For a Port Channel interface, enter the keywords port-channel then a number. The
range is from 1 to 128.
NOTE: This command also enables you to view information corresponding to
a range of ports.
• For port-channel interfaces, you can specify multiple ports as port-range.
For example, if you want to display information corresponding to all ports
between 1 and 4, specify the port range as show interfaces port-
channel 1 - 4.
brief (OPTIONAL) Enter the keyword brief to display only the port channel number, the
state of the port channel, and the number of interfaces in the port channel.
Interfaces 553