Service Manual

Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM and added support to display the interface configurations
corresponding to a range of ports..
8.3.16.1 Introduced on the S4820T.
Usage Information The following describes the show interfaces port-channel command shown in the following example.
Field Description
Port-Channel 1... Displays the LAG’s status. In the Example, the status of the LAG’s LAG fate-sharing
group (“Failover-group”) is listed.
Hardware is... Displays the interface’s hardware information and its assigned MAC address.
Port-channel is
part...
Indicates whether the LAG is part of a LAG fate-sharing group (“Failover-group”).
Internet address... States whether an IP address is assigned to the interface. If an IP address is assigned,
that address is displayed.
MTU 1554... Displays link and IP MTU.
LineSpeed Displays the interface’s line speed. For a port channel interface, it is the line speed of the
interfaces in the port channel.
Members in this... Displays the interfaces belonging to this port channel.
ARP type:... Displays the ARP type and the ARP timeout value for the interface.
Last clearing... Displays the time when the show interfaces counters were cleared.
Queueing strategy. States the packet queuing strategy. FIFO means first in first out.
packets input... Displays the number of packets and bytes into the interface.
Input 0 IP packets... Displays the number of packets with IP headers, VLAN tagged headers, and MPLS
headers. The number of packets may not add correctly because a VLAN tagged IP
packet counts as both a VLAN packet and an IP packet.
0 64-byte... Displays the size of packets and the number of those packets entering that interface.
This information is displayed over two lines.
Received 0... Displays the type and number of errors or other specific packets received. This
information is displayed over three lines.
Output 0... Displays the type and number of packets sent out the interface. This information is
displayed over three lines.
Rate information... Displays the traffic rate information into and out of the interface. Traffic rate is displayed
in bits and packets per second.
Time since... Displays the time since the last change in the configuration of this interface.
Example
(EtherScale)
Dell#show interfaces port-channel
Port-channel 1 is down, line protocol is down
Hardware address is 00:1e:c9:f1:00:05, Current address is 00:1e:c9:f1:00:05
Interface index is 1107755009
Minimum number of links to bring Port-channel up is 1
554 Interfaces