Service Manual

Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip domain-list
Configure names to complete unqualified host names.
Syntax
ip domain-list name
To remove the name, use the no ip domain-list name command.
Parameters
name Enter a domain name to be used to complete unqualified names (that is, incomplete
domain names that cannot be resolved).
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To configure a list of possible domain names, configure the ip domain-list command up to six times.
If you configure both the ip domain-name and ip domain-list commands, the software tries to resolve
the name using the
ip domain-name command. If the name is not resolved, the software goes through the list
of names configured with the ip domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command. To view a DNS-related configuration, use the show
running-config resolve command.
Related Commands ip domain-name — specifies a DNS server.
ip domain-lookup
To address resolution (that is, DNS), enable dynamic host-name.
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command Modes CONFIGURATION
572 IPv4 Routing