Service Manual

Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
To fully enable DNS, also specify one or more domain name servers with the ip name-server command.
The Dell Networking OS does not support sending DNS queries over a VLAN. DNS queries are sent out all other
interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related Commands
ip name-server — specifies a DNS server.
show hosts — Views the current bindings.
ip domain-name
Configure one domain name for the switch.
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name Enter one domain name to be used to complete unqualified names (that is, incomplete
domain names that cannot be resolved).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can only configure one domain name with the ip domain-name command. To configure more than one
domain name, configure the ip domain-list command up to six times.
To enable dynamic resolution of hosts, use the following steps:
• specify a domain name server with the ip name-server command
• enable DNS with the ip domain-lookup command
To view current bindings, use the show hosts command.
Related Commands
ip domain-list — configures additional names.
IPv4 Routing 573