Service Manual

ip name-server
Enter up to six IPv4 addresses of name servers. The order you enter the addresses determines the order of their use.
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the no ip name-server ip-address command.
Parameters
ipv4-address Enter the IPv4 address, in dotted decimal format, of the name server to be used.
ipv4-address2...
ipv4-address6
(OPTIONAL) Enter up five more IPv4 addresses, in dotted decimal format, of name
servers to be used. Separate the addresses with a space.
Defaults No name servers are configured.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
The system does not support sending DNS queries over a VLAN. DNS queries are sent out on all other interfaces,
including the Management port.
ip proxy-arp
Enable proxy ARP on an interface.
Syntax
ip proxy-arp
To disable proxy ARP, use the no ip proxy-arp command.
Defaults Enabled.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands show ip interface — displays the interface routing status and configuration.
ip route
Assign a static route to the switch.
Syntax
ip route {destination mask {ip-address | interface [ip-address] | [distance] |
[permanent] | tag tag-value}}
578 IPv4 Routing