Service Manual
ip source-route
Enable the system to forward IP packets with source route information in the header.
Syntax
ip source-route
To drop packets with source route information, use the no ip route-source command.
Defaults Enabled.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
ip tcp initial-time
Define the wait duration in seconds for the TCP connection to be established.
Syntax
ip tcp initial-time <8-75>
To restore the default behavior, which causes the wait period to be set as eight seconds, use the no ip tcp
initial-time command.
Parameters
<8-75> Wait duration in seconds for the TCP connection to be established.
Command Modes
CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Introduced on the MXL platform.
Usage Information You can configure the amount of time for which the device must wait before it attempts to establish a TCP
connection. Using this capability, you can limit the wait times for TCP connection requests. Upon responding to
the initial SYN packet that requests a connection to the router for a specific service (such as SSH or BGP) with a
SYN ACK, the router waits for a period of time for the ACK packet to be sent from the requesting host that will
establish the TCP connection.
show ip tcp initial-time
Displays the interval that you configured for the device to wait before the TCP connection is attempted to be established.
Syntax
show ip tcp initial-time
Command Modes
EXEC
580 IPv4 Routing