Service Manual

Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol
route) is preferred over the Management Static route. Also, Management static routes and the Management
Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4
and IPv6 management routes. This command manages both tables.
Related Commands
interface ManagementEthernet — configures the Management port on the system.
show arp
Display the ARP table.
Syntax
show arp [interface interface | ip ip-address [mask] | macaddress mac-address
[mac-address mask]] [static | dynamic][summary]
Parameters
interface interface (OPTIONAL) Enter the following keywords and slot/port or number information:
For the Management interface, enter the keyword managementethernet then
the slot/port information.
For a Port Channel interface, enter the keyword port-channel then a number.
The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
For a VLAN, enter the keyword vlan then a number from 1 to 4094.
ip ip-address mask (OPTIONAL) Enter the keyword ip then an IP address in the dotted decimal format.
Enter the optional IP address mask in the slash prefix format (/ x).
macaddress mac-
address mask
(OPTIONAL) Enter the keyword macaddress then a MAC address in nn:nn:nn:nn:nn:nn
format. Enter the optional MAC address mask in nn:nn:nn:nn:nn format also.
static (OPTIONAL) Enter the keyword static to view entries entered manually.
dynamic (OPTIONAL) Enter the keyword dynamic to view dynamic entries.
summary (OPTIONAL) Enter the keyword summary to view a summary of ARP entries.
Command Modes EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4.0.0 Added usage information for Clear arp-cache.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following example shows two VLANs that are associated with a private VLAN (PVLAN) (refer to Private
VLAN (PVLAN).
If you have entered the 'clear arp-cache' command to remove a large number of ARP entries and the
command is still being processed in the background, an error message is displayed as follows if you attempt to
enter the 'show arp’ command: "Clear arp in-progress.Please try after sometime!
582 IPv4 Routing