Service Manual

Field Description
Destination Lists the destination IP address.
Gateway Displays either the word “direct” and an interface for a directly connected route or the
remote IP address used to forward the traffic.
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is listed.
EC Displays the number of ECMP paths.
Example
Dell#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-Addr Port VId EC
------------------------------------------------------------------
10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00 BLK HOLE 0 0
Dell>
Related Commands clear ip fib stack-unit — clear FIB entries on a specified stack-unit.
show ip interface
View IP-related information on all interfaces.
Syntax
show ip interface [interface | brief] [configured]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword Loopback then a number from 0 to
16383.
• For the Management interface, enter the keyword ManagementEthernet then
zero (0).
•
For the Null interface, enter the keyword null then zero (0).
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a brief summary of the interfaces and
whether an IP address is assigned.
configured (OPTIONAL) Enter the keyword configured to display the physical interfaces with
non-default configurations only.
Command Modes
• EXEC
• EXEC Privilege
588 IPv4 Routing