Service Manual
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip route all command in the following example.
Field Description
(undefined) Identifies the type of route:
• C = connected
• S = static
• R = RIP
• B = BGP
• IN = internal BGP
• EX = external BGP
• LO = Locally Originated
• O = OSPF
• IA = OSPF inter area
• N1 = OSPF NSSA external type 1
• N2 = OSPF NSSA external type 2
• E1 = OSPF external type 1
• E2 = OSPF external type 2
• i = IS-IS
• L1 = IS-IS level-1
• L2 = IS-IS level-2
• IA = IS-IS inter-area
• * = candidate default
• > = non-active route
• + = summary routes
Destination
Identifies the route’s destination IP address
Gateway Identifies whether the route is directly connected and on which interface the route is
configured.
Dist/Metric Identifies if the route has a specified distance or metric.
Last Change Identifies when the route was last changed or configured.
Example
Dell#show ip route all
Codes:C- connected, S - static, R - RIP
B- BGP, IN - internal BGP, EX - external BGP, LO - Locally Originated
O- OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1
N2- OSPF NSSA external type 2, E1 - OSPF external type 1
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default
>- non-active route + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 3.0.0.0/8 via 100.10.10.10, So 2/8 120/1 00:07:12
592 IPv4 Routing