Service Manual

show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
Syntax
show ip traffic
Command Modes EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show ip traffic summary shown in the following example.
Keyword Definition
unknown protocol... No receiver for these packets. Counts packets whose protocol type field is not
recognized by the system.
not a gateway... Packets can not be routed; the host/network is unreachable.
security failures... Counts the number of received unicast/multicast packets that could not be forwarded
due to:
• route not found for unicast/multicast; ingress interfaces do not belong to the
destination multicast group
• destination IP address belongs to reserved prefixes; the host/network is unreachable
bad options... Unrecognized IP option on a received packet.
Frags: IP fragments received.
... reassembled Number of IP fragments that were reassembled.
... timeouts Number of times a timer expired on a reassembled queue.
... too big Number of invalid IP fragments received.
... couldn’t
fragment
Number of packets that could not be fragmented and forwarded.
...encapsulation
failed
Counts packets which could not be forwarded due to ARP resolution failure. The system
sends an arp request prior to forwarding an IP packet. If a reply is not received, the
system repeats the request three times. These packets are counted in encapsulation
failed.
Rcvd:
...short packets The number of bytes in the packet are too small.
...bad length The length of the packet was not correct.
...no port
broadcasts
The incoming broadcast/multicast packet did not have any listener.
...socket full The applications buffer is full and the incoming packet are dropped.
The F10 Monitoring MIB provides access to the following statistics.
• IP Statistics: Bcast: Received: Object = f10BcastPktRecv, OIDs = 1.3.6.1.4.1.6027.3.3.5.1.1
IPv4 Routing
595