Service Manual

Parameters
default Use the default CAM profile settings, and set the CAM as follows:
• L3 ACL (ipv4acl): 6
• L2 ACL(l2acl): 5
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 1
• L2 QoS (l2qos): 1
l2acl 1-10 ipv4acl
1-10 ipv6acl 0-10
ipv4qos 1-10 l2qos
1-10
Allocate space to support IPv6 ACLs. Enter all of the profiles and a range. Enter the CAM
profile name then the amount to be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or copy
run start), then reload the system.
The total amount of space allowed is 16 FP blocks. System flow requires three blocks and these blocks cannot be
reallocated.
When configuring space for IPv6 ACLs, the total number of Blocks must equal 13.
Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which is from 0 to 10. The
ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
cam-acl-egress
Allocate space for IPv6 egress ACLs.
Syntax
cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default Use the default CAM profile settings, and set the CAM as follows:
• L2 ACL(l2acl): 1
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
l2acl 1-4 ipv4acl 1- 4
ipv6acl 0-4
Allocate space to support IPv6 ACLs. Enter all of the profiles and a range. Enter the CAM
profile name then the amount to be allotted. The total space allocated must equal 13. The
ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
IPv6 Access Control Lists (IPv6 ACLs) 607