Service Manual

0-5 Enter the stack member unit identifier to restore only the mentioned stack-unit.

all Enter the keyword all to restore all units in the stack.

bootvar Enter the keyword bootvar to reset boot line.

clear-all Enter the keywords clear-all to reset the NvRAM, boot environment variables, and

the system startup configuration.

nvram Enter the keyword nvram to reset the NvRAM only.

Command Modes EXEC Privilege

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.5(0.1) Added bootvar as a new parameters.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

Restoring factory defaults deletes the existing startup configuration and all persistent settings (stacking, fan-out,

and so forth).

When restoring all units in a stack, all the units in the stack are placed into stand-alone mode.

When restoring a single unit in a stack, that unit placed in stand-alone mode. No other units in the stack are

affected.

When restoring units in stand-alone mode, the units remain in stand-alone mode after the restoration. After the

restore is complete, the units power cycle immediately.

CAUTION: There is no undo for this command.

Following are the factory-default environment variables:

• baudrate

• primary_boot

• secondary_boot

• default_boot

• ipaddr

• gatewayip

• netmask

• macaddr

• mgmtautoneg

• mgmtspeed100

• mgmtfullduplex

File Management