Service Manual

Usage Information When you enable soft-reconfiguration for a neighbor and you execute the clear ip bgp soft in command,
the update database stored in the router replays and updates are reevaluated. With this command, the replay and
update process is triggered only if route-refresh request is not negotiated with the peer. If the request is
negotiated (after execution of clear ip bgp soft in), BGP sends a route-refresh request to the neighbor
and receives all of the peer’s updates.
Related Commands clear ip bgp ipv6 unicast soft — activates inbound policies for IPv6 routes without resetting the BGP TCP session.
capture bgp-pdu neighbor (ipv6)
Enable capture of an IPv6 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv6-address direction {both | rx | tx}
To disable capture of the IPv6 BGP neighbor packet, use the no capture bgp-pdu neighbor ipv6-
address command.
Parameters
ipv6-address Enter the IPv6 address of the target BGP neighbor.
direction {both | rx |
tx}
Enter the keyword direction and a direction — either rx for inbound, tx for
outbound, or both.
Defaults Not configured.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
capture bgp-pdu max-buffer-size — enables route reflection between the route reflector and the clients.
show capture bgp-pdu neighbor — configures a route reflector and clients.
capture bgp-pdu max-buffer-size
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
100-102400000 Enter a size for the capture buffer.
Defaults 40960000 bytes
Command Modes
• EXEC
• EXEC Privilege
IPv6 Border Gateway Protocol (IPv6 BGP) 647