Service Manual

To delete a neighbor distribution list, use the no neighbor {ipv6-address | peer-group-name}
distribute-list prefix-list-name {in | out} command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group.
prefix-list-name Enter the name of an established prefix list. If the prefix list is not configured, the default
is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
neighbor filter-list — assigns a AS-PATH list to a neighbor or peer group.
neighbor route-map — assigns a route map to a neighbor or peer group.
neighbor filter-list
Configure a BGP filter based on the AS-PATH attribute.
Syntax
neighbor [ipv6-address | peer-group-name] filter-list aspath access-list-name
[in | out]
To delete a BGP filter, use the no neighbor [ipv6-address | peer-group-name] filter-list
aspath access-list-name [in | out] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
peer-group-name Enter the name of the peer group to apply the filter to all routers in the peer group.
access-list-name Enter the name of an established AS-PATH access list. If the AS-PATH access list is not
configured, the default is permit (to allow routes).
in Enter the keyword in to filter inbound BGP routes.
out Enter the keyword out to filter outbound BGP routes.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
700 IPv6 Border Gateway Protocol (IPv6 BGP)