Service Manual

NOTE: The :: notation specifies successive hexadecimal fields of zeros.

peer-group-name Enter the name of the peer group.

map-name Enter the name of an established route map. If the Route map is not configured, the

default is deny (to drop all routes).

in Enter the keyword in to filter inbound routes.

out Enter the keyword out to filter outbound routes.

Defaults Not configured.

Command Modes ROUTER BGPV6-ADDRESS FAMILY

Command History

Version Description

9.9(0.0) Introduced on the FN IOM.

9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

When you apply a route map to outbound routes, only routes that match at least one section of the route map are

permitted.

If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used

in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound

policies on that peer.

neighbor route-reflector-client

Configure a neighbor as a member of a route reflector cluster.

Syntax

neighbor {ipv6-address | peer-group-name} route-reflector-client

To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration, use the no

neighbor {ipv6-address | peer-group-name} route-reflector-client command.

Parameters

ipv6-address Enter the IPv6 address in the x:x:x:x::x format.