Service Manual

Usage Information
The first time you enter this command it configures the neighbor as a route reflector and members of the route-
reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
Syntax
network ipv6-address [route-map map-name]
To remove a network, use the no network ipv6-address [route-map map-name] command.
Parameters
ipv6-address Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of an established route
map.
If the route map is not configured, the default is deny (to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The software resolves the network address configured by the network command with the routes in the main
routing table to ensure that the networks are reachable using non-BGP routes and non-default routes.
Related Commands redistribute — redistributes routes into BGP.
redistribute
Redistribute routes into BGP.
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution {connected | static} command.
Parameters
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static Enter the keyword static to redistribute manually configured routes. These routes are
treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of an established route
map.
704 IPv6 Border Gateway Protocol (IPv6 BGP)