Service Manual

iscsi enable
Globally enable iSCSI optimization.
Syntax
iscsi enable
To disable iSCSI optimization, use the no iscsi enable command.
Parameters
enable Enter the keyword enable to enable the iSCSI optimization feature.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information When you enable the iSCSI feature using the iscsi enable command, flow control settings are set to rx on
tx off on all interfaces.
iscsi priority-bits
Configure the priority bitmap that advertises in the iSCSI application TLVs.
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the no iscsi priority-bits command.
Defaults 4 (0x10 in the bitmap)
Command Modes PROTOCOL LLDP (only on the global, not on the interface)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
iscsi profile-compellant
Configure the auto-detection of Dell Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
iSCSI Optimization 717