Service Manual

Usage Information To build name-to-systemID mapping tables through the protocol, use this command. All show commands that
display systems also display the hostname.
Related Commands clns host — defines a name-to-NSAP mapping.
ignore-lsp-errors
Ignore LSPs with bad checksums instead of purging those LSPs.
Syntax
ignore-lsp-errors
To return to the default values, use the no ignore-lsp-errors command.
Defaults In IS-IS, the default deletes LSPs with internal checksum errors (no ignore-lsp-errors).
Command Modes ROUTER ISIS
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information IS-IS normally purges LSPs with an incorrect data link checksum causing the LSP source to regenerate the
message. A cycle of purging and regenerating LSPs can occur when a network link continues to deliver accurate
LSPs even though there is a link causing data corruption. This process could cause disruption to your system
operation.
ip router isis
Configure IS-IS routing processes on an interface and attach an area tag name to the routing process.
Syntax
ip router isis [tag]
To disable IS-IS on an interface, use the no ip router isis [tag] command.
Parameters
tag (OPTIONAL) The tag you specify identifies a specific area routing process. If you do not
specify a tag, a null tag is assigned.
Defaults No processes are configured.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information To assign a network entity title to enable IS-IS, use the net command.
Related Commands
• net — configures an IS-IS network entity title (NET) for the routing process.
• router isis — enables the IS-IS routing protocol.
738 Intermediate System to Intermediate System (IS-IS)