Service Manual

To disable LACP debugging, use the no [config | events | pdu [interface [in | out]]]
command.
Parameters
config (OPTIONAL) Enter the keyword config to debug the LACP configuration.
events (OPTIONAL) Enter the keyword events to debug the LACP event information.
pdu (OPTIONAL) Enter the keyword pdu to debug the LACP Protocol Data Unit information.
interface in | out (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a Ten-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
Optionally, enter an in or out parameter:
• Receive enter in
• Transmit enter out
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-timeout command.
Defaults 1 second
Command Modes INTERFACE (conf-if-po-number)
Command History
Version 9.2(0.0) Introduced on the M I/O Aggregator.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information This command applies to dynamic port-channel interfaces only. When applied on a static port-channel, this
command has no effect.
Link Aggregation Control Protocol (LACP) 767