Service Manual

lacp port-priority
To influence which ports will be put in Standby mode when there is a hardware limitation that prevents all compatible ports from
aggregating, configure the port priority.
Syntax
lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value command.
Parameters
priority-value Enter the port-priority value. The higher the value number, the lower the priority. The
range is from 1 to 65535. The default is 32768.
Defaults 32768
Command Modes INTERFACE
Command History
Version 9.2(0.0) Introduced on the M I/O Aggregator.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
lacp system-priority
Configure the LACP system priority.
Syntax
lacp system-priority priority-value
Parameters
priority-value Enter the port-priority value. The higher the value number, the lower the priority. The
range is from 1 to 65535. The default is 32768.
Defaults 32768
Command Modes INTERFACE
Command History
Version 9.2(0.0) Introduced on the M I/O Aggregator.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
port-channel mode
Configure the LACP port channel mode.
Syntax
port-channel number mode [active] [passive] [off]
Parameters
number Enter the keywords number then a number.
active Enter the keyword active to set the mode to the active state.
NOTE: LACP modes are defined in Usage Information .
passive Enter the keyword passive to set the mode to the passive state.
768 Link Aggregation Control Protocol (LACP)