Service Manual

mac-address-table disable-learning
Disable MAC address learning from LACP or LLDP BPDUs.
Syntax
mac-address-table disable-learning [lacp | lldp]
Parameters
lacp Enter lacp to disable MAC address learning from LACP BPDUs.
lldp Enter LLDP to disable MAC address learning from LLDP BPDUs.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the MXL .
Usage Information
If you use the mac-address-table disable-learning command without specifying any option, the
system does not learn source MAC addresses from LACP or LLDP BPDUs.
mac-address-table static
Associate specific MAC or hardware addresses to an interface and virtual local area networks (VLANs).
Syntax
mac-address-table static mac-address output interface vlan vlan-id
To remove a MAC address, use the no mac-address-table static mac-address output
interface vlan vlan-id command.
Parameters
mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
output interface Enter the keyword output then one of the following interfaces for which traffic is
forwarded:
• For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.2(0.0) Introduced on the M I/O Aggregator.
774 Layer 2