Service Manual

Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a topology change.
Syntax
[no] mac-address-table station-move refresh-arp
Defaults Enabled
Command Modes CONFIGURATION
Command History
Version 9.9(0.0) Modified the default option from none to Enabled.
Version 9.2(0.0) Introduced on the M I/O Aggregator.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information For details about using this command, refer to the “NIC Teaming” section of the Layer 2 chapter in the Dell
Networking OS Configuration Guide.
mac learning-limit
Limit the maximum number of MAC addresses (static + dynamic) learned on a selected interface.
Syntax
mac learning-limit address_limit [dyanmic] [no-station-move| station-move]
[sticky]
Parameters
address_limit Enter the maximum number of MAC addresses that can be learned on the interface. The
range is from 1 to 1000000.
dynamic (OPTIONAL) Enter the keyword dynamic to allow aging of MACs even though a
learning limit is configured.
no-station-move (OPTIONAL) Enter the keywords no-station-move to disallow a station move
(associate the learned MAC address with the most recently accessed port) on learned
MAC addresses.
station-move (OPTIONAL) Enter the keywords station-move to allow a station move on learned
MAC addresses.
sticky (OPTIONAL) Enter the keyword sticky to allow configuring the sticky mac feature
along with the learning limit.
Defaults dynamic
NOTE: “Static” means manually entered addresses, which do not age.
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Layer 2 775