Service Manual

static (OPTIONAL) Enter the keyword static to display only those MAC addresses
specifically configured on the switch. Optionally, you can also add one of these
combinations: address/mac-address, interface/interface, or vlan vlan-
id
.
address mac-
address
(OPTIONAL) Enter the keyword address then a MAC address in the nn:nn:nn:nn:nn:nn
format to display information on that MAC address.
interface interface (OPTIONAL) Enter the keyword interface then the interface type, slot and port
information:
For a Port Channel interface, enter the keywords port-channel then a number.
The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
interface interface-
type
(OPTIONAL) Instead of entering the keyword interface then the interface type, slot
and port information, as above, you can enter the interface type, then just a slot number.
vlan vlan-id (OPTIONAL) Enter the keyword vlan then the VLAN ID to display the MAC address
assigned to the VLAN. The range is 1 to 4094.
count (OPTIONAL) Enter the keyword count, then optionally, by an interface or VLAN ID, to
display total or interface-specific static addresses, dynamic addresses, and MAC
addresses in use.
Command Modes
EXEC
EXEC Privilege
Command History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information The following describes the show mac-address-table command shown in the following example.
Column Heading Description
VlanId Displays the VLAN ID number.
Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Type Lists whether the MAC address was manually configured (Static), learned dynamically
(Dynamic), or associated with a specific port (Sticky).
Interface Displays the interface type and slot/port information. The following abbreviations
describe the interface types:
gi — Gigabit Ethernet then a slot/port.
po — Port Channel then a number. The range is from 1 to 255 for TeraScale.
so —SONET then a slot/port.
te — 10 Gigabit Ethernet then a slot/port.
State Lists if the MAC address is in use (Active) or not in use (Inactive).
Example
Dell#show mac-address-table
VlanId Mac Address Type Interface State
Layer 2 779