Service Manual

protocol lldp (Configuration)
Enable the LLDP globally on the switch.
Syntax
protocol lldp
To disable LLDP globally on the chassis, use the no protocol lldp command.
Defaults Enabled.
Command Modes CONFIGURATION (conf-lldp)
Command History
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
protocol lldp (Interface)
Enter the LLDP protocol in INTERFACE mode.
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp command from Interface mode.
Defaults LLDP is not enabled on the interface.
Command Modes INTERFACE (conf-if-interface-lldp)
Command History
Version 8.3.16.1
Usage Information
Before LLDP can be configured on an interface, it must be enabled globally from CONFIGURATION mode. This
command places you in LLDP mode on the interface; it does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global configurations. When you execute
the no protocol lldp from INTERFACE mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
Syntax
show lldp neighbors [interface] [detail]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
For a 10-Gigabit Ethernet interface, enter the keyword tenGigabitEthernet
then the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
detail (OPTIONAL) Enter the keyword detail to display all the TLV information, remote
management IP addresses, timers, and LLDP tx and rx counters.
Link Layer Discovery Protocol (LLDP) 795