Service Manual

Related Commands
protocol lldp (Configuration) — enables LLDP globally.
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med guest-voice-signaling
To advertise a separate limited voice service for a guest user when the guest voice control packets use a separate network policy than the
voice data, configure the system.
Syntax
advertise med guest-voice-signaling {vlan-id layer2_priority DSCP_value} |
{priority-tagged number}
To return to the default, use the no advertise med guest-voice-signaling {vlan-id
layer2_priority DSCP_value} | {priority-tagged number} command.
Parameters
vlan-id Enter the VLAN ID. The range is from 1 to 4094.
layer2_priority Enter the Layer 2 priority. The range is from 0 to 7.
DSCP_value Enter the DSCP value. The range is from 0 to 63.
priority-tagged
number
Enter the keywords priority-tagged then the Layer 2 priority. The range is from 0
to 7.
Defaults unconfigured.
Command Modes CONFIGURATION (conf-lldp)
Command History
9.9(0.0) Introduced on the FN IOM.
Version 8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands
debug lldp interface — debugs LLDP.
show lldp neighbors — displays the LLDP neighbors.
show running-config lldp — displays the LLDP running configuration.
advertise med location-identification
To advertise a location identifier, configure the system.
Syntax
advertise med location-identification {coordinate-based value | civic-based
value | ecs-elin value}
To return to the default, use the no advertise med location-identification {coordinate-
based value | civic-based value | ecs-elin value} command.
798 Link Layer Discovery Protocol (LLDP)