Service Manual

ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address} list name
command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard access list that contains the RP
address that should be treated as the default peer. If no access list is specified, then all
SAs from the peer are accepted.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If a list is not specified, all SA messages received from the default peer are accepted. You can enter multiple
default peer commands.
ip msdp log-adjacency-changes
Enable logging of MSDP adjacency changes.
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
ip msdp mesh-group
To be a member of a mesh group, configure a peer.
Syntax
ip msdp mesh-group {name} {peer address}
Multicast Source Discovery Protocol (MSDP) 811