Service Manual

ip multicast-msdp
Enable MSDP.
Syntax
ip multicast-msdp
To exit MSDP, use the no ip multicast-msdp command.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
show ip msdp
Display the MSDP peer status, SA cache, or peer summary.
Syntax
show ip msdp {peer peer address | sa-cache | summary}
Parameters
peer peer address Enter the keyword peer then the peer address in a dotted decimal format (A.B.C.D.).
sa-cache Enter the keywords sa-cache to display the Source-Active cache.
summary Enter the keyword summary to display an MSDP peer summary.
Defaults Not configured.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell#show ip msdp peer 100.1.1.1
Peer Addr: 100.1.1.1
Local Addr: 100.1.1.2(639) Connect Source: none
State: Established Up/Down Time: 00:00:08
Timers: KeepAlive 60 sec, Hold time 75 sec
SourceActive packet count (in/out): 0/0
SAs learned from this peer: 0
SA Filtering:
Input (S,G) filter: none
Output (S,G) filter: none
Dell#
816 Multicast Source Discovery Protocol (MSDP)