Service Manual

Defaults 15
Command Modes EXEC
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.5(0.0) Introduced the support for roles on the MXL 10/40GbE Switch.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Users entering EXEC Privilege mode or any other configured privilege level can access configuration commands.
To protect against unauthorized access, use the enable password command to configure a password for the
enable command at a specific privilege level. If no privilege level is specified, the default is privilege level 15.
NOTE: If you are authorized for the EXEC privilege mode by your role, you do not need to enter an
enable password.
Related Commands enable password — configures a password for the enable command and to access a privilege level.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optic-info-update interval seconds
To disable optical power information updates, use the no enable optic-info-update interval
command.
Parameters
interval seconds Enter the keyword interval then the polling interval in seconds. The range is from 120
to 6000 seconds. The default is 300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Replaces the enable xfp-power-updates command.
Usage Information To enable polling and to configure the polling frequency, use this command.
enable secure
Creates configurable MXL mode where Chassis Management Controller (CMC) access to MXL is bypassed for the elements critical to the
security certifications.
Syntax
enable secure
To disable the secure mode, use no enable secure command.
Parameters None
82 Control and Monitoring