Service Manual

Version Description
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all the IPv6 neighbor addresses stored on the control
processor (CP).
Syntax
show ipv6 neighbors [ipv6-address] [cpu {rp1 [ipv6-address] | rp2 [ipv6-
address]}] [interface interface]
Parameters
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
CPU Enter the keyword cpu then either rp1 or rp2 (Route Processor 1 or 2), optionally then
an IPv6 address to display the IPv6 neighbor entries stored on the designated RP.
interface interface Enter the keyword interface then the interface type and slot/port or number
information:
• For a Fast Ethernet interface, enter the keyword fastEthernet then the slot/port
information.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN, enter the keyword vlan then the VLAN ID. The range is from 1 to 4094.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell# show ipv6 neighbors
IPv6 Address Expires(min) Hardware Address State Interface VLAN CPU
------------------------------------------------------------------
100::1 0.03 00:00:00:00:00:22 DELAY Te 0/12 - CP
fe80::200:ff:fe00:22 232 00:00:00:00:00:22 STALE Te 0/12 - CP
500::1 0.60 00:01:e8:17:5c:af REACH Te 0/13 - CP
fe80::200:ff:fe00:17 232 00:00:00:00:00:29 REACH Te 0/14 - CP
900::1 0.60 00:01:e8:17:5c:b1 STALE Po 23 - CP
400::1 0.60 00:01:e8:17:5c:ae REACH te 0/2 Vl 100 CP
Dell#
Neighbor Discovery Protocol (NDP) 841