Service Manual

Parameters
number Specify the number of paths. The range for OSPFv2 is from 1 to 16. The default for
OSPFv2 is 4 paths. The range for OSPFv3 is from 1 to 64. The default for OSPFv3 is 8
paths.
Defaults 4
Command Modes ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Added support for OSPFv3.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
mib-binding
Enable this OSPF process ID to manage the SNMP traps and process SNMP queries.
Syntax
mib-binding
To mib-binding on this OSPF process, use the no mib-binding command.
Defaults none.
Command Modes ROUTER OSPF
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command is either enabled or disabled. If no OSPF process is identified as the MIB manager, the first OSPF
process is used.
If an OSPF process has been selected, it must be disabled prior to assigning new process ID the MIB responsibility.
network area
Define which interfaces run OSPF and the OSPF area for those interfaces.
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal format. The primary address is
required before adding the secondary address.
mask Enter a network mask in /prefix format. (/x)
878 Open Shortest Path First (OSPFv2 and OSPFv3)