Service Manual

show config
Display the non-default values in the current OSPF configuration.
Syntax
show config
Command Modes ROUTER OSPF
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the M I/O Aggregator.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
Syntax
show ip ospf process-id
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process ID is entered,
command applies only to the first OSPF process.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information If you delete all the network area commands for Area 0, the show ip ospf command output does not list Area
0.
The following describes the show ip ospf command shown in the following example.
Line Beginning
with
Description
“Routing Process...” Displays the OSPF process ID and the IP address associated with the process ID.
“Supports only...” Displays the number of Type of Service (TOS) rouse supported.
“SPF schedule...” Displays the delay and hold time configured for this process ID.
884 Open Shortest Path First (OSPFv2 and OSPFv3)