Service Manual

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command History
Version Description
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Related Commands telnet — telnets to another device.
ip tftp source-interface
Assign an interface’s IP address in outgoing packets for TFTP traffic.
Syntax
ip tftp source-interface interface
Parameters
interface Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword loopback then a number from zero (0)
to 16383.
• For a Port Channel, enter the keywords port-channel then a number. The range
is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE mode, where you can set the access
conditions for the designated line.
Syntax
line {console 0 | vty number [end-number]}
90 Control and Monitoring