Service Manual

Dell(conf-router_ospf-1)#show config
!
router ospf 1
timers spf 2 5 msec
Dell(conf-router_ospf-1)#
Dell(conf-router_ospf-1)#end
Dell#
timers throttle lsa all
Configure LSA transmit intervals.
Syntax
timers throttle lsa all {start-interval | hold-interval | max-interval}
To return to the default, use the no timers throttle lsa command.
Parameters
start-interval Set the minimum interval between initial sending and resending the same LSA. The range
is from 0 to 600,000 milliseconds.
hold-interval Set the next interval to send the same LSA. This interval is the time between sending the
same LSA after the start-interval has been attempted. The range is from 1 to 600,000
milliseconds.
max-interval Set the maximum amount of time the system waits before sending the LSA. The range is
from 1 to 600,000 milliseconds.
Defaults
• start-interval: 0 msec
• hold-interval: 5000 msec
• max-interval: 5000 msec
Command Modes ROUTER OSPF
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information LSAs are sent after the start-interval and then after hold-interval until the maximum interval is reached. In
throttling, exponential backoff is used when sending same LSA, so that the interval is multiplied until the maximum
time is reached. For example, if the start-interval 5000 and hold-interval 1000 and max-interval 100,000, the LSA
is sent at 5000 msec, then 1000 msec, then 2000 msec, them 4000 until 100,000 msec is reached.
timers throttle lsa arrival
Configure the LSA acceptance intervals.
Syntax
timers throttle lsa arrival arrival-time
To return to the default, use the no timers throttle lsa command.
908 Open Shortest Path First (OSPFv2 and OSPFv3)