Service Manual

Parameters
seconds
Enter the time interval in seconds. The range is from 1 to 65535 seconds.
Defaults 40 seconds (Ethernet).
Command Modes INTERFACE
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
By default, the dead interval is four times longer than the default ipv6 ospf hello-interval command.
ipv6 ospf encryption
Configure an IPsec encryption policy for OSPFv3 packets on an IPv6 interface.
Syntax
ipv6 ospf encryption {null | ipsec spi number esp encryption-algorithm [key-
encryption-type] key athentication-algorithm [key-encryption-type] key}}
To remove an IPsec encryption policy from an interface, use the no ipv6 ospf encryption spi number
command.
To remove null authentication on an interface to allow the interface to inherit the authentication policy configured
for the OSPFv3 area, use the no ipv6 ospf encryption null command.
Parameters
null Causes an encryption policy configured for the area to not be inherited on the interface.
ipsec spi number Security Policy index (SPI) value that identifies an IPsec security policy. The range is from
256 to 4294967295.
esp encryption-
algorithm
Encryption algorithm used with ESP.
Valid values are: 3DES, DES, AES-CBC, and NULL.
For AES-CBC, only the AES-128 and AES-192 ciphers are supported.
key-encryption-
type
(OPTIONAL) Specifies if the key is encrypted.
Valid values: 0 (key is not encrypted) or 7 (key is encrypted).
key
Text string used in authentication.
The required lengths of a non-encrypted or encrypted key are:
3DES - 48 or 96 hex digits; DES - 16 or 32 hex digits; AES-CBC -32 or 64 hex digits for
AES-128 and 48 or 96 hex digits for AES-192.
authentication-
algorithm
Specifies the authentication algorithm to use for encryption. Valid values are MD5 or
SHA1.
Open Shortest Path First (OSPFv2 and OSPFv3) 921