Service Manual

ipv6 router ospf
Enable OSPF for IPv6 router configuration.
Syntax
ipv6 router ospf process-id
To exit OSPF for IPv6, use the no ipv6 router ospf process-id command.
Parameters
process-id
Enter the process identification number. The range is from 1 to 65535.
Defaults none
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
maximum-paths
Enable the software to forward packets over multiple paths.
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths command.
Parameters
number Specify the number of paths. The range is from 1 to 64. The default is 8 paths.
Defaults 4
Command Modes ROUTER OSPF for OSPFv3
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Added support for OSPFv3.
8.3.16.1 Introduced on the MXL 10/40GbE Switch IO Module.
passive-interface
Disable (suppress) sending routing updates on an interface.
Syntax
passive—interface {default | interface}
To enable sending routing updates on an interface, use the no passive-interface interface command.
924 Open Shortest Path First (OSPFv2 and OSPFv3)