Service Manual

To return to the default, use the no timers spf command.
Parameters
delay Enter a number as the delay. The range is from 0 to 2147483647. The default is 5
seconds.
holdtime Enter a number as the hold time. The range is from 0 to 2147483647. The default is 10
seconds.
msec Enter the keyword msec to specify the time interval value in milli seconds.
NOTE: If you do not specify the msec option, the timer values are considered
as seconds.
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
Command Modes ROUTER OSPFv3 for OSPFv3
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11(0.0) Introduced the msec keyword.
9.9(0.0) Introduced on the FN IOM.
9.8(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information Setting the delay and holdtime parameters to a low number enables the switch to an alternate path quickly but
requires more CPU usage.
Example
Dell#
Dell#conf
Dell(conf)#ipv6 router ospf 1
Dell(conf-ipv6-router_ospf)#timer spf 2 5 msec
Dell(conf-ipv6-router_ospf)#
Dell(conf-ipv6-router_ospf)#show config
!
ipv6 router ospf 1
timers spf 2 5 msec
Dell(conf-ipv6-router_ospf)#
Dell(conf-ipv6-router_ospf)#end
Dell#
Open Shortest Path First (OSPFv2 and OSPFv3) 931