Service Manual

ip redirect-group
Apply a redirect list (policy-based routing) on an interface. You can apply multiple redirect lists to an interface by entering this command
multiple times.
Syntax
ip redirect-group redirect-list-name
To remove a redirect list from an interface, use the no ip redirect-group name command.
Parameters
redirect-list-name Enter the name of a configured redirect list.
Defaults none
Command Modes INTERFACE (conf-if-vl-)
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series TeraScale.
7.4.2.0 Added support for LAG and VLAN interfaces.
7.7.1.0 Introduced on the E-Series ExaScale.
Usage Information
You can apply any number of redirect-groups to an interface. A redirect list can contain any number of configured
rules. These rules includes the next-hop IP address where the incoming traffic is to be redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop. Otherwise, the normal routing
table is used to forward traffic. When a redirect-group is applied to an interface and the next-hop is reachable, the
rules are added into the PBR CAM region. When incoming traffic hits an entry in the CAM, the traffic is redirected
to the corresponding next-hop IP address specified in the rule.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
Related Commands
• show cam pbr – displays the content of the PBR CAM.
• show ip redirect-list – displays the redirect-list configuration.
ip redirect-list
Configure a redirect list and enter REDIRECT-LIST mode.
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
Parameters
redirect-list-name Enter the name of a redirect list.
Policy-based Routing (PBR) 933