Service Manual

seq
Configure a filter with an assigned sequence number for the redirect list.
Syntax
seq sequence-number {permit | redirect {ip-address | tunnel tunnel-id}[track
<obj-id>] }}{ip-protocol-number | protocol-type} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [bit] [operator]{source-
port source-port| source-port-range start-port - end-port} {destination-port
destination-port| destination-port-range start-port - end-port}
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-number Enter a number from 1 to 65535.
permit Enter the keyword permit assign the sequence to the permit list.
redirect Enter the keyword redirect to assign the sequence to the redirect list.
ip-address Enter the IP address of the forwarding router.
tunnel Enter the keyword tunnel to configure the tunnel setting.
tunnel-id Enter the keyword tunnel-id to redirect the traffic.
track Enter the keyword track to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
ip-protocol-number Enter the keyword ip-protocol-number then the number from 0 to 255 for the
protocol identified in the IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following
TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
•
psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
Policy-based Routing (PBR) 937