Service Manual

operator (OPTIONAL) For the TCP and UDP parameters only. Enter one of the following logical
operand:
eq = equal to
neq = not equal to
gt = greater than
lt= less than
range = inclusive range of ports (you must specify two ports for the port command
parameter.)
source port Enter the keywords source-port then the port number to be matched in the ACL rule
in the ICAP rule
destination-port Enter the keywords destination-port then the port number to be matched in the
ACL rule in the ICAP rule.
source-port-range Enter the keywords Source-port-range then the range of the start port to end port
to be matched in the ACL rule in the ICAP rule.
destination-port-
range
Enter the keywords destination-port-range then the range of the start port to
end port to be matched in the ACL rule in the ICAP rule.
Defaults none
Command Modes REDIRECT-LIST
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.7(0.0) Added support for thetrack-id on the MXL.
9.4(0.0) Added support for removing the Sonet interface on the MXL 10/40GbE Switch IO
Module.
show cam pbr
Displaysthe PBR CAM content.
Syntax
show cam pbr {[interface interface] | stack—unit slot-number port-set number]}
[summary]
Parameters
interface interface Enter the keyword interface then the name of the interface.
stack–unit number Enter the keyword stack-unit then the slot number. The range is from 0 to 11 .
port-set number Enter the keywords port-set then the port-pipe number. The range is from 0 to 0.
summary Enter the keyword summary to view only the total number of CAM entries.
Defaults none
Command Modes EXEC
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
938 Policy-based Routing (PBR)